spherical mirror
英 [ˈsferɪkl ˈmɪrə(r)]
美 [ˈsferɪkl ˈmɪrər]
网络 球面镜; 球面鏡; 球面反射镜
双语例句
- Theoretical Study on Measurement of Small Signal Gain by ASE Method with a Spherical Mirror
球面反射镜的放大自发辐射方法测量小信号增益的理论研究 - Various components are the spherical mirror, the form are simple, and the structure is compact.
系统各组元均为球面镜，形式简单、结构紧凑。 - The matrix eigenvalues method is used to analyze the laser cavity in which the traditional spherical mirror is replaced by the phase type diffraction optical elements.
运用矩阵本征值方法，对用位相型二元光学元件构成的激光谐振腔进行了数值计算，重点分析了圆形反射镜腔在不同菲涅耳数条件下的模结构参量特性。 - Small holes are arranged on the spherical reflecting mirror and the crossing portion of the spherical reflecting mirror and the long shaft of the ellipse, and the small holes are lamp holes.
在上述球面反射镜上，在其和椭圆的长轴相交处开一小孔，即为灯口。 - A standard spherical mirror was measured on this test platform to verify the feasibility of the platform.
在此平台上对标准球面镜进行了测量，验证了此平台的适用性。 - Associating problems encountered in teaching of an introduction to electromagnetic fields, two viewpoints concerning spherical mirror method and calculation of electric field energy are pointed out.
结合“电磁场导论”课程教学中遇到的问题，指出有关球面镜像、电场能量计算的两点看法。 - Grinding and Inspection of Spherical Mirror with Long Curvature Radius
特长曲率半径球面反光镜的磨制与检测 - The elimination and regulation of astigmatism in spherical mirror folded cavities
球面镜折迭腔中光模象散的调整与消除 - Rapid development of optical processing technique calls for new requirement for surface characterization testing technology on spherical mirror of large aperture.
光学制造技术的发展，对大口径光学元件的面形检测提出了更新要求。 - By selecting appropriate cavity configurations, the astigmatism of optical mode in spherical mirror folded cavities can be partially eliminated and regulated.
选择合适的腔结构，球面镜折迭腔中光模的象散可以部分地消除和调整。 - It is computer-controlled polishing technology, using it the authors can polish a deep aspherical mirror just like polish a spherical mirror.
这是一种用计算机控制的磨镜技术，通过它可以像加工球面一样来加工一个深度的非球面。 - The conclusion is obtained that the image distortion of off-axis spherical mirror is the least.
从而得出离轴球面反射镜所成图像畸变最小。 - A Spherical Mirror F-P Interferometer in Submillimeter Wave Region
亚毫米波球面镜F-P干涉仪 - According to the characteristics of solar simulation optics and considering reduction of fabrication cost we can replace the paraboloidal mirror with a spherical mirror that can be made up by many small segments.
根据太阳模拟器光学系统的特性，同时也为降低制造成本，准直镜可以采用球面反射镜来代替原本的抛物面反射镜，并且采用多个小镜拼接而成。 - In this paper studies how to simulate fulfill in single spherical mirror and centered system of spherical surfaces. In this paper, hardware design of system, simulation debug, software composition are introduced in detail.
论文中研究了单球面及共轴球面系统成像的模拟实现过程，详细地介绍了硬件设计、仿真调试、及软件的编制，并给出了电路图和程序清单。 - This paper discusses why the interference phenomena from the Newton's ring which consist of plain glass and spherical mirror cannot be observed clearly.
讨论了由平面玻璃板与球面反射镜（以下简称球面镜）组成的牛顿环仪观察不到干涉现象的原因； - By using a reflective spherical mirror with large numerical aperture, the light scattered by individual particles is collected over a large angular range of 20 ° to 160 °.
散射光收集系统为单一大数值孔径的球面反射镜，其对粒子散射光的收集角范围从20°到160°。 - And the error correction for interferometer by means of computer image processing is presented. The feature of spherical mirror is examined.
同时，阐述了采用计算机图像处理技术修正干涉仪系统误差和检测球面镜的方法。 - Using KirchhofE-Fresnel integrated equation, it is shown that a laser cavity consisted ofa grating and a spherical mirror is equivalent to a common cavity with a tilted mirror.
从基希霍夫-费涅耳积分方程出发，证明了“光栅腔”与带有倾斜反射镜的普通谐振腔是等价的。 - It further introduces the measurement of curvature radius of spherical mirror through Michelson interferometer& Newton's ring interference.
介绍用迈克耳逊干涉仪&牛顿环干涉法测定球面镜曲率半径的方法。 - Adopting spherical mirror and plane mirror can notablely improve the utilization of the light source in the system of light source.
在光源系统中采用球面聚光镜和平面反射镜，可大幅提高光源的利用率。 - This paper mainly introduces design principles and technology parameters of WIDE System. To Ensure realization of those parameters, criteria for designing, manufacturing and testing of spherical mirror and back projection screen of this system are discussed.
本文重点介绍了WIDE系统的设计原则和技术指标的确定，以及为保证指标的实现，确定球面反射镜和后投影屏设计、制造和检测指标。 - The theoretical model of measurement of small signal gain by ASE method with a spherical mirror was presented.
提出了球面反射镜的放大自发辐射（ASE）方法测量小信号增益的理论模型，给出了相应的小信号增益系数的计算公式。 - On the theory of scattering by a spherical mirror
球面镜的散射理论 - Study of the off axis spherical mirror line focus system used for X ray laser experiments
用于X光激光实验的离轴球面反射镜线聚焦系统的研究 - The peak power, the frequency output and average power output of the spherical mirror trihedral reflector set with different output angles is measured with the particle simulation method.
用粒子模拟的方式研究了球面镜三反射镜在设置不同角度输出口的情况下的峰值功率、频率输出以及平均功率输出。 - We apply LOD technology to the process of Curved Mirror Image ( containing cylindrical mirror, spherical mirror and so on), and call the corresponding simplified model to participate in the Cylindrical Mirror Image according to the conventional relations between the view point and cylindrical mirror.
我们将LOD模型简化技术运用于各类曲面镜成像的过程中（包括柱面镜，球面镜等），根据模型与镜距、视距之间的关系约定调用对应的简化模型参与镜面反射成像。 - Consider the present processing technology and art, the design with spherical secondary mirror is beneficial to its manufacture and cost reduction. The design with free-form surfaces is compact and diffraction limited, but its manufacture cost is still high as things as are at the moment.
结合当前加工工艺进行分析比较，指出次镜为球面的方案，有利于加工，且成本低；自由曲面方案结构紧凑，成像质量达到衍射极限，但目前加工成本还比较高。